VEVOR 2-in-1 Electric Rebar Bender 1700W 3 Angle up to 1 Inch #8 (4-25mm)

About this item

• High Compatibility: The rebar bending machine is widely used in construction engineering for bending or cutting rebar, steel bar, steel rod, screw thread steel, carbon steel, round steel, etc.
• Ultra-Fast Working Speed: This rebar bender and cutter machine is designed with excellent performance. It helps save valuable person-hours by bending rebar. Supports bending and cutting diameters ranging from 0.16 to 0.98 inches / 4 to 25 mm within 3.5 to 4 seconds. Bending Angle: 0-180°.
• 1700W Pure Copper Coil Motor: This rebar cutter and bender features a 1700W pure copper motor, which can run quietly with low noise and significantly improve your working efficiency, reducing unnecessary wear. Besides, a copper motor can extend this rebar bender cutter's operating life to a large extent.
• Angle Adjustment Knobs: This rod bending machine has two slide-type angle selectors, which can help you accurately bend any angle from 0-180 degrees. Preset angle locks are designed for repeating the same angle bending. When bending processing, the angle of point 1 must be bigger than point 2. Otherwise, the machine can not operate normally.
• Sturdy Machine Body: The bar bender machine adopts a sturdy iron machine body and durable Idler Wheel. Ø78 iron Gyre Idler Wheel and Ø94 Fixed Idler Wheel are stronger and not easy to break. Moreover, it can stand super-hard rebar with strong clamping force, which can help to reduce steel rebar waste.