Home Heating, Venting & Cooling Heaters Heater Accessories Heat Exchanger

VEVOR Heat Exchanger 3/4” MNPT Ports Brazed Plate Heat Exchanger 30 Plate heat exchanger plate exchanger Stainless Steel 316L Flat Plate Heat Exchanger Plate Chiller Wort for Hydronic Heating

Interface: 3/4 inch MNPT Number of Plates: 30 pcs

Questions and Answers

11 Questions

Hello. what is the burst pressure? Need 42mpa - is this usable for R410a coolant and can i get one for brazing instead of threads

Answer This Question

The design pressure of this model is 4.5Mpa. It can be used for the refrigerant of 410a, but pay attention to the threaded pipe. The refrigerant shall be welded with copper pipe. There are steps in the threaded pipe, which can be directly put into the copper pipe for welding.

By vevor

Helpful? 24

Hello. I would like to use this heat exchanger for steam-to-water heat transfer. The steam temperature is max 200°C and pressure around 1,6 MPa. In the description is max pressure 3MPa, however is that achievable pressure at this high temperatures? Thank you.

Answer This Question

3MPa refers to the design pressure of the plate changer, and the steam can pass through the plate changer with a pressure of 0.3MPa.

By vevor

Helpful? 5

Funcționează cu freon r32?

Answer This Question

Da, dar se recomandă ca presiunea de lucru să fie în 30 bar.

By vevor

Helpful? 1

Hi Is heat exchanger 12v powered

Answer This Question

This heat exchanger is made of stainless steel and copper. It does not heat itself. The heat exchange effect is achieved by transferring heat between the cold side and the hot side through the partition heat exchange, so there is no 12V power supply.

By vevor

Helpful? 0

Hello, are there two straight pipes running through it?

Answer This Question

Hello, there is no straight tube inside the product, the plate exchanger is layered.

By vevor

Helpful? 0