Customer Reviews for Apf-500 X Axis Power Feed Milling Machine135lb Bridgeport Plastic Gear Knee Type

Used on my lion mill. Fitted it today, instructions are a bit rough, but I expected that. All the parts needed were supplied. Runs well and seems to have plenty of power. 110 volt supply from my mill powers it well, also tested it with a "builders" 110 volt transformer. If it continues to perform I'll add more to my machine.

Very easy to install very inexpensive ,Works very well installed in an industrial application and its holding its own against Servo Brand feeds costing 6 times as much!

Used on my lion mill. Fitted it today, instructions are a bit rough, but I expected that. All the parts needed were supplied. Runs well and seems to have plenty of power. 110 volt supply from my mill powers it well, also tested it with a "builders" 110 volt transformer. If it continues to perform I'll add more to my machine.

Used on my lion mill. Fitted it today, instructions are a bit rough, but I expected that. All the parts needed were supplied. Runs well and seems to have plenty of power. 110 volt supply from my mill powers it well, also tested it with a "builders" 110 volt transformer. If it continues to perform I'll add more to my machine.

I installed the powerfeed on my Bridgeport , i had to make a couple of parts to make it work for my application. The bushing was about 5/8 to short and I had to make a short extension to place the hand back on . I think it was worth the little aggravation. It works just fine , I have been using it for about a month now with no problems .

Very easy to install very inexpensive ,Works very well installed in an industrial application and its holding its own against Servo Brand feeds costing 6 times as much!

I bought this for my small-ish column mill-drill, so it took a bit of fabrication to get it operational. I have installed similar units on Bridgeport clones and I'm sure this power feed would have fit a Bridgeport or Bridgeport clone perfectly.One nice thing is that the feed gear has angled teeth, so it is smoother than the straight cut gears I have seen on most other power feeds.It has good torque, but at very low speeds the motor is slightly jerky. At the slowest speeds I am likely to use (to get a smooth finish) it is very smooth.Overall I am very happy, and the price was fantastic.