Customer Reviews for VEVOR Laser Tube 100W CO2 Laser Tube 1430mm Glass Laser Tube Professional Special Coating Technology Tube Laser Cutting Tube for Laser Engraving Machine and Cutting Machine

Worked great for about 2 hours of use, then cracked at the cathode. I never exceed 70% power and have propper cooling with distilled water.Update:Customer service has been awesome. They are sending me out a replacement. I will update again once it arrives and I can run it a bit.

El pedido llego perfectamente en solo 5 d_s, funciona como el original.

My old tube was firing many beams at once and you can't cut or engrave that way. I replaced the tube very easily and we are back up and running.

Seemed more like a 50w bulb, but shipped and worked fine

Good product. Arrived on time and well packaged. Only just installed so can't comment on real power output but apparently legitimately 100w as stated. Seemingly excellent value for money.

El vendedor es r_ido al mandar el producto, si tienes cualquier problema lo soluciona rapidamente y el producto es de buena calidad.

Worked great for first few hours of use and now lost cutting power. Never exceeded 80% power. Can not get response from seller.Update: they have offered to replace the tube.

This is a perfect replacement for my eBay CN 50W 500 x 300mm Laser!! The 'dot' coming ut of the laser is much smaller (3mm) than the 'higher-end' tube it replaced (~6mm) Haven't put it through it's paces but seems I will get my money's worthOnly had to contact company re: cosmetic alignment of Cathode - assured me not worry b/c 1yr replacement - quick & professional response.

labeling suggested the tube was recently manufactured. this tube is not a direct fit for K40 laser, although the tube can be run with existing equipment and power supply (cautiously). SELLER to CLIENT CARE is IMPRESSIVEShipping was excellent once product was in the system ! needs some works on dispatching the order. over all, generally satisfied. further, review tube is installed and tested!TO further, tube is installed(new mounts 55mm) and seems to work. (predominate purple light). Connection to the electrodes is a difficult task, as the terminals are TOO short(extending only 3/32") to connect properly.however, a spring (only) type Marquette could be used (done/siliconed). Soldering "ball type" is not recommended as fear of thermal upset is at risk. New 60 watt PSU installed. Full testing, when put into service, updates to follow

Very good product