Customer Reviews for VEVOR 6 Inch Powerful Precise Clamping Vice, 59.4lbs Vice Machine Vice Precision Vice Accessory Set, 1-3/4Inch Jaw Precise Clamping Lock Table Vice

Very pleased with my purchase. These two smaller vices complement a larger one. I was expecting to see the coolant drain, but this rotating model is perhaps too small for that.

It's cheap and cheerful, for the money it's bloody good, I ran a dti over it and it was within 0.01mm on X,Y&Z. edges needed easing as many youtube reviews have said, The base was pretty good I ran a stone over it and although not absolutely perfect I wasn't concerned about anything. The jaws I will probably replace as when the vice arrived they were ground flat on the top, I assume once assembled. once taken apart there is no repeatability. I had to jiggle them about a bit to get them back trammed with the dti. but hey ho it's not a Kurt and not a Kurt price. I can't really comment on the swivel base as I only checked for parallelism. for the deg if I wanted accuracy I would use a sine bar anyway. One thing I did notice was 0 deg started underneath the screw, making 90 deg to the side where there is a mark for setting, no problem for me though. I have the vice on the bed with no base, used my own T nuts and bolts as they were better. For the money it is very good value in my opinion, and would not hesitate in purchasing another should the need arise .

Perfect vise for my drillpress right size good precision and easy to use and also strong and no lift acctioowhen tightens

After a quick deburring of the bottom, set this up on a surface plate. The bed was flat to within 0.01 mm (0.00025") and the fixed jaw square to within the ability of my tools to measure it. The jaws needed a little adjustment to get them aligned, and the tops are then flat to within 0.015 mm. Finish is generally nice, but I would dismantle, clean and lubricate before using to get the smoothest action, like any other machine tool. Pretty impressive for the price.

Really good value for money. I bought two of these, that I can use together for long parts. For the work I am doing, these are good enough.

Very good value for money, the 6" is a beast and on the slight big side for 21cm milling table, but it works fine, I am very satisfied.

Works great and delivers excellent value for money. Edges of unmachined surfaces can be sharp and would benefit from a more detailed finishing process. Locating dowels of different widths could be supplied to make mounting easier.

I have bought 2 pcs. machine vices (1 pc. 3 inch and 1 pc. 4 inch) Was delivered quickly. Is very good quality and the goods are exactly as described from Vevor. Very satisfied and can safely recommend this product

I forhold til pris og min bruk er Vevors 6 tommer kraftige presisjonsskrustikke helt ok . Har modifisert den litt .

Very good value. Strong and well made. More than accurate enough for my hobby and repair shop. The only reason I did not give it Five stars all round was the very quaint English the manual is written in. Still, if you can't drive a vice without a manual you are probably not safe to be in a workshop anyway.