Customer Reviews for Bench Clamp Vise High Precision Clamping Vise 6 Inch Jaw Width CNC Vise Fixed Jaw

Haven't used it as it was a bit too tall for my router, but it looked like it is made relatively good, I haven't measured anything on it, so I don't know how flat ground or parallel it is etc, but it seemed good enough that I bought another 4" vise since that one's lower.

A lot of vice for the price and a good heavy casting, well ground surface finish on the sliding surfaces and jaws. I just had to tidy up the edges of the base with a file as they were still sharp from grinding. The base will eventually be scraped in but for now it’s good enough. I think the maximum deviation over all with the vice fully open from fixed jaw to moving was with in 0.06mm I have provided photos showing DTI deviation but can only post five

Good value good quality. You need to adjust the Jaws to true parallel. Easy to do slacken Allen bolts and set to parallel with milling table

I love it, good quality and firm.. great for the home shop. It came fast and safe, and the handle is cast iron The jaws are reversible

Good for the money. Finishing is mediocre but the action seems accurate and squareness is adequate for hobby machining use. Arrived without damage.

Good quality, easy to use. Fixing bolts were too big for my mini mill but I had some already I could use.

Got this after struggle with a smaller vise. These are modelled after the famous design of the American Kurt vise, but at a tiny fraction of the price. So wasn't expecting it to be as good as it turned out to be. Was well packed, came with a fixing kit, and was no trouble to setup. After fly cutting a part both sides on parallels the thickness was almost same on all corners (just over 0.01mm). Extremely good clamping force.

Very Pleased, just right for my mini mill **************************************************************************************************************************

Arrived very quickly, well packed. Very strongly built considering low price. Used for a week of continuous milling and never slipped once. Overkill for my Chester 626 mill I hadn't realised how big it was! Delighted with it except for the handle which was a little oversize and was marking the hexagon shaft. However the remedy was to substitute handle for a spanner. It still rates 11 out of 10 for me.

I just use this on my drill press and for the price it works for me .