Customer Reviews for VEVOR 3.0KW 220V Air Cooled Spindle Motor CNC Air Cooling Spindle Motor for CNC Engraving Milling Machine

Works great paired with a gt series vfd, lot of torque on the lower end.

Used for cnc machine I built worked great

I am changing my review because I reached out to Mophorn on an issue I had with the bearings in my spindle. I was not expecting much help as I was outside the return window, but explained to them that I bought it months before using because I was still building my machine. I didn_ ask for a full refund but was hoping for a little compensation. Mophorn went out of there way to help me and immediately offered me a FULL REFUND! This spindle has good reviews, so mine must of been an unusual problem. It is a strong, accurate, high value for money spindle. At the end of the day, know that if you do have a problem with something that Mophorn does care about there name and WILL TAKE CARE OF YOU!

Funziona bene, silenzioso.

this is one solid bit of kit. so many negative reviews though and only think they either have had bad luck or simply have no idea on how to set them up or to use it.mine is use on a daily basis and ok they get a bit warm but never had a problem. Two of my colleagues loved my upgrade so they asked me to install the same setup on their machines. Love it

Die Spindel wurde sehr schnell geliefert, war aber nicht in Ordnung. Der Rotor hat beim ersten Versuch ihn von Hand zu drehen geklemmt. Bei einem ersten Test am Wechselrichter (der korrekt eingestellt war) hat sich schon bei niedriger Drehzahl (6000 1/min) ziemliche Ger?usche von sich gegeben, wurde sehr warm und hat dann auch leicht gequalmt. Nach Reklamation wurde mir Ersatz geschickt, die hat nicht geklemmt und h?rt sich auch besser an. Das defekte Teile musste ich nicht zur_kschicken.

Acaba de llegar el pedido, no lo he puesto en marcha todav_, pero me da muy buenas sensaciones. Parace un producto de muy buena calidad. Gracias.

I originally purchase an air-cooled 1.5KW spindle, however it was incredibly noisy and so I ended up getting this one to try and avoid having to wear hearing protection around it. It seems very well-made and the noise it generates is a fraction of the air-cooled spindle; it's not silent or close to it, but the noise it generates is so much less than an air-cooled spindle so I'm happy with it. It comes with two ER11 collets-- a 1/8" and another that I haven't looked at, as all my bits are 1/8".Very reasonable price and performance.

Just installed. Replaced similar one. Seems to run smooth and true through break in. VERY LITTLE runout, like almost none. Can_ speak to how long it will last or bearing quality but at the price, it seems worth the risk. But 4 for the cost of replacing one Taiwan version. Would recommend at this point.

Betreibe den Motor mit einen LENCE 84xx Vektor.gut ausbewuchte und bis 7000 u/min eigentlich sehr leise ... dann wirds etwas lauter aber NULL Vibrationenwenn mann den luftgek_ten Motor unter Last min uteren Drehzalbereich betreib sollte mann ihn zusatzk_en, mach ich mit einen externe L_ter ....bin sehr zufriden