Customer Reviews for VEVOR 5 Minute Morticer JIG1 Door Lock Mortiser Kit Lock Fitting Jig Door Lock Mortiser Kit with 3 Cutters 18 22 25mm

Obviously a copy of the Souber tool, this is not self centering but is the offset version. More verstaile but it does take a little longer to set it up. Once set, it works very well.

This jig is brilliant and it saves me a hell of a lot of time on doors

It's fine as far as it goes. The cutters supplied are too big for most locks. They are an M10 thread and you would think that any similar mortiser would make their cutters with an M10 thread so I bought a 16mm dia cutter from Souber. But although the Souber mortiser looks virtually identical, it uses some sort of medieval thread of about 7.5mm. And I don't seem to be able to get hold of a 16mm dia cutter with an M10 thread.I shall probably find a suitable rod the same diameter as on my original mortiser and ask a friend with a workshop to run a tap of this medieval thread down into its end. If the Chinese company which made this advertised 16mm cutters, I would buy one but I can't find whether they do.Buy it if you are happy with oversized slots but you may have problems getting replacement cutters.

Great bit of kit at a great price excellent delivery. There’s on one issue is could do with a 23mm cutter as the 22mm one is a bit little for the latches but you can get a smaller diameter latch but if not a bit of chisel work and job spot on.

Good bit of kit, and makes easy work of mortice all I will say is take your time setting it up and and take your time racking out and make sure you have clamped it well

For the perfect mortice you can't go wrong

*******Amazing product *******Recently, I started doing Woodworks as a hobby, it���s a passion.Ordered, I ordered this product recently to install a deadlock to most of my doors. I must say the product is very recommendable, reliable and very easy to use.I will give 5 out of 5 stars******Value for money.******Easy to use.Accuracy and finery ���Precise

I purchased this kit because I had something similar a few years ago.If you have time on your hands then this kit can help you to show off.Levelling this on a door takes way too much time. Yes, you can do some marks on it for fast use in the future but they should have thought of that when you play with "mm".The stoppers on the rails on both sides are from plastic and because of the weight while you drilling for the lock plate move easily and you will get over the lines.It can be improved but for now, it will rest In a corner to rust. I can do the same job and much faster with a router.

This is a extremely handy lock jig can mortise the lock with a drill as opposed to a router, takes a little bit of getting used to but it works well once you get the hang of it I done 4 oak doors yesterday mortise and face plate in roughly 25 mins just be careful with the debt setting as it can slide making tou go deeper than needed I use a bit of tape to stop it from sliding, for the price you can't go wrong overall happy with it

Makes fitting locks much quicker. You still need a chisel to square off the corners, but this is a minor detail.