Ich habe die Nass-Kernbohrmaschine mit Bedenken gekauft, da in den Rezessionen immer wieder die Qualität bemäkelt wurde.Ja, es ist kein Profi-Gerät.Ein paar Verbesserungen sollte man wirklich unbedingt machen bevor man sich an die Arbeit macht:1. Der Schlauch ist Müll, kauft euch beim Baumarkt um 2 Euro einen dünnen Gewebeschlauch der auf die vorhandenen Anschlüsse passt. Der Mitgelieferte Schlauch klebt an den Innenwänden teilweise zusammen und lässt kein Wasser durch.2. Abstürzen des hinteren, losen Endes der Bohrhalterung bei Einsatz an einer Wand. Ohne das schwabbelt es doch ganz schön umher. Ich hab einfach einen Holzklotz untergestellt.3. fixieren des Kabels mit Kabelbinder an der Bohrmaschine: Das Kabel verlässt genau dort die Bohrmaschine wo auch die Kurbel für den Bohrvorschub montiert ist. Hier sollte man das Kabels so fixieren dass man nicht ständig anstößt beim Kurbeln.Danach gehts los:- Der mitgelieferte Metall-Spreizdübel hält bombenfest in einer Stahlbetonwand.- Die Fixierung an der Wand war also kein Problem, mit Wasserwaage ausrichten.- Kühlwasser kam bei mir aus dem Gartenschlauch, sanft aufdrehen und die mitgelieferten Gummistöpsel passt genau über einen Gardena-Anschluss.- FI-Personenschutzschalter reseten und Hauptschalter ein.- Es gibt keinen Sanftanlauf, die Maschine läuft sofort vollgas los, also nicht schrecken. Der Motor klingt wie ein Küchenmixer aus den 60-er Jahren, aber mit Gehörschutz halb so schlimm.- Rutschkupplung gibts auch keine, also eine Hand am FI-Personenschutzschalter auf der Stopp-Taste lassen damit man im Notfall bei Blockierung sofort ausschalten kann (sonst glühen die Kohlebürsten auf und sind weg). Bei mir hat kein einziges Mal was blockiert, aber man weiß ja nicht...-Langsam starten damit sich die mitgelieferte ca. 100mm Bohrkrone in die Mauer beissen kann. - Maschine schwabbelt etwas. Hier kann man mit der Abstützung per Holzpflock oder mit dem Knie wenn man an Bodennähe bohrt abgeholfen werden.- Nach 1 cm kann man meh