Customer Reviews for Vevor Cross Slide Table Milling Drilling Machine Worktable 5-1/2" X 12" X Y Axis

There is a little slop in the XY when it arrives, but tightening the shims and a teardown/rebuild fixes most of it. Unless you are doing heavy milling operations--BUY IT! I turned my milling table into the XY of a DIY Lathe. So long as the shims are tight, the cuts are clean! I'm incredibly impressed by the craftsmenship of this milling table. Definitely definitely worth the money!

Super Pr?zisionsfr?stisch Kreuzarbeitstisch war von der Qualit?t sehr _errascht sehr gerne wieder

Lourde table solide en fonte arriv_ intacte dans un coffret bois un peu mince _ant donn le poids de l'appareil. Les surfaces sont bien usin_s, les glissi_es sont bien r_l_s, sans aucun coincement. Au transversal, course de 210, et jeu au vernier correct. Au frontal, course de 105, et jeu plus important, puisque de 1/4 de tour. Mais cela n'emp_he pas de travailler correctement. J'ai install cette table sur ma vieille perceuse colonne Rhino. Impeccable !

Per lavori di hobbistica molto valido interamente in ghisa, molto robusta e discretamente precisa. Unica pecca la mancanza dei 2 dadi che fermano i volantini, me li sono dovuti procurare a parte, per questo ho dato solo 4 stelle. Arrivata prima dei tempi previsti nella sua pratica cassetta di legno. Tutto sommato stato un buon acquisto.

It_ ok for the price and my hobby projects. Probably need to pair the 3 and 4 vice that mounts to table with TBlocks ..?

Desplaza perfectamente suave pero deber_ tener un cinta con medidas para ver el desplazamiento

Good value heavy cast iron milling table. No slack and adjustable bearings. Works far better than expected.

The slides are basicly good but need a bit of work. I scraped the machining marks out and scrapped the slides in. Also removed the sharp edges and the slides are great now. The cast iron is a bit on the soft side but it will be ok. I will add that I am a machine tool fitter machinist by trade.D.P.

Bueno, nesesita algunos reglaje , holgura de las guias.Las marcas en los nonyos casi no se ven.La mesa esta robusta y estable.Si se puede mejorar la rugosidad del frezado de las guias va a ser una buena mesa de frezar/taladrar.ME GUSTA

I received mine and took it apart and cleaned all the shipping coatings. Applied some ways oil to all sliding surfaces and spindle oil to the threaded hand wheel screws, adjusted the gibs to tighten up play/backlash. Set on my drill press and made a quick test run on some Delrin block. I was very pleased and now can use my drill press for some basic milling on light materials which is exactly why I purchased it. Mission accomplished and I'd recommend it.BTW it is very heavy so you'll most likely need to brace your drill press table - depending on its sturdiness.