Customer Reviews for VEVOR Portable Sawmill 14"-36" Guide Bar Galvanized Steel Chainsaw Planking 0.2"-11.81" Thickness, Wood Lumber Cross Cutting Saw Mill for Builders and Woodworkers, Silver

Love the quality build on this. One disappointment however as 1 part was missing. I had to manufacture my own piece. Part missing was the crossbar used to fasten the handle and add rigidity to the unit. Other than that I am happy with the purchase.

Good quality and I'm very happy with this mill and the price was good.

assembly was not hard. take your time. instructions were correct but drawings on assembly not the greatest. I have been using it for months to slab logs to make live edge cutting boards etc. no complaints. very good value. unit is light and not hard to use. Becareful that you dont place the nose clamp where it will bind your bar nose gear. get it centered. using one of these can be very dangerous being around the saw. play safe.

Cutting slices of walnut. Nice!

Easy to put together, the instructions are a bit out of order but it took two minutes to go back and revise. Just don't lock anything down tight until have it all together! I used this to mill up a 30" diameter maple into 1.5' slabs, and two 15" pine trees into 1' and 3" planks all with live edge. I have a lot of planing and sanding ahead of me when it is dry but this wood will make a work bench in my garage, allow some creative projects, and save me a bundle. The chain guard on the end is thin and broke off on the second day of cutting, I might replace it with some thicker stainless steel but it is really not an issue as you don't need to get near the saw nose if you are doing it right. I twisted off a U-bolt when tightening, but it is a standard hardware store item and I replaced it in minutes. I would have bought North American and got the Granberg but it was back ordered for weeks and the local Ottawa stores only had a shorter version of the Granberg in stock. It worked out well. I will do another large maple next summer and make an amazing kitchen island (I hope). Watch the nuts! I put one on finger tight and forgot to torque it down - it spun off in 10 seconds of cutting! Other than that I never had anything come loose. Check your saws breather / air filter frequently. The fine dust from end cutting clogs them up fast! Sharpen frequently too. I was very happy with the work I completed using this device.

Easily assembled. It is fairly sturdy when set up properly but you have to hand tighten each section and its somewhat cumbersome and time consuming. we managed to get nice straight cuts out of it. I feel it was worth the money.First time ever using an Alaskan chain saw mill. It is a fair amount of work on the saw so you need a good powerful one. It took us about 25 mins for a 6' long by 14' wide cut. We used a 20" bar and it was maxed out for width.

My saw mill arrived on time and everything was as expected. Good deal for the price and works as it should. Was missing 8 washers but no big deal, have lots of that stuff lying around pine at home. Great for moderate use which I knew before purchasing. If you plan on cutting all day every day in large quantities buy a more expensive model. But all in all great deal, great design and easy to use. ?

Telle que la description

Easy to assemble. Easily adjustable. Seems very sturdy. I am really looking forward to using it!

Anschlag ist nicht ganz parallel zur S?geschiene, l??t sich aber durch unterlegen von d_ner Scheibe beheben.Preiswert.