Customer Reviews for VEVOR Spray Paint Pressure Pot Tank, 10L/2.5gal Air Paint Pressure Pot, 1.5mm+4mm Two Nozzles Two Spray Paint Guns for Industry Home Decor Architecture Construction Automotive Painting, 60PSI Max

I'm really happy with this pot. There are loads of videos on YouTube showing how to convert it for resin casting. I pressurise mine to 60 psi and it holds perfectly. Bear on mind you'll always lose a couple of psi as the air cools back down. To convert this in the same way I have, you'll need... 3/8x1/4 bsp male x male fitting 1/4 bsp Tee (all female) 1/4 female to male ball valve 1/4 male to whatever your compressor or pump uses 1/4 pressure gauge (the pot comes with one but I chose to get a sturdier one) Ptfe tape The pot also comes with a pressure release valve There are two holes in the lid, one is 1/4 and one us 3/8. I screwed the pressure release valve straight into the 1/4. I assembled the other as in the photo but switched the gauge and inlet around. use 3 wraps of ptfe on each thread. This is how I put it all together, do lots of research and make sure you're confident :) If this was useful or if you have any questions, pop to instagram and say hi! https://www.instagram.com/discover_rings/?hl=en-gb

It works perfect and it´s easy to adjust amount of coulor for different needs. Maybe the hoses could be a bit softer. Was also a bit hard to put all things together, but eventually I managed to make it work.

Not used it yet as I have not been doing anything to paint but we'll let you know later if it isn't good product

Excellent piece of kit. Sealed lid for first time, filled it with air to 50psi. Disconnected compressor and left for 3 days. The psi was still 50, never had that before with a pressure pot. Used it several times since and still holding pressure, no leakage at all. Good quality. I cut off the liquid out pipe inside as it interfered with caddy. Excellent thanks.

Fantastic Quality product, fast delivery and no damage to the box or product. Very impressive. Will order again

Έλαβα εχθές το δοχείο πίεσης χρωμάτων αλλά λείπουν από την συσκευασία οι 4 ρόδες. Παρακαλώ να μου τις στείλετε.Ευχαριστώ.

Excellent sprayer, reducing painting time by 80 per cent .very easy to clean and set up for the products I am putting through it , thank you very much for a very very good product

I ordered the smaller 10l pressure pot from Vevor. It seems designed for resin casting but still has a paint pipe installed in case you want to spray paint. This gets in the way of casting. I think Vevor should remove it. I did - with an angle grinder. I couldn't unscrew it. The pot works fine up to 50 psi (which is high as I need to go). No bubbles in the resin. No leaks from any point on the pot either, so no need for the supplied sealant. For £114, this pressure pot is way cheaper than the competition. I didn't find any CE quality marks and I haven't tested the safety pressure release (60psi) but it works well. If Vevor supplied castors the price would be a little higher, but I think they could remove the paint pipe (as an option?) or blank off that fitting without a major cost and sell it for the purpose most purchasers will use it for - resin casting. It would be good if they supplied an adjustable caddy as well as the internal base plate. Overall however, I'm very satisfied.

good quality great value, well built and hoping for many years use, have been always haappy with items bought from vevor

Great spray gun. I use this for spraying furniture and the finish is excellent. I would recommend.