Customer Reviews for VEVOR Spray Paint Pressure Pot Tank, 30L/8gal Air Paint Pressure Pot with Manual Mixing Agitator, Leak Repair Sealant for Industry Home Decor Architecture Construction Automotive Painting, 70PSI Max

I think it does the job.Mine was shipped without the regulator, hoses, gauge or valve which the Companyquickly sent a new set,I converted mine into a presure tank for drawing air out of my resin andwood castings. It works great for my intended use. I would like to get some extra lid seals just in case.VERY SATISFIED

Performed better than expected,good purchase for the money

Ich habe dieses Produkt gekauft um mir damit eine Druckkammer f_ Epoxidharz zu bauen. Der Umbau war kinderleicht und war auch sofort dicht. Meine Produkte aus Epoxid kommen glasklar heraus bei nur 3bar Betriebsdruck. Verwendet habe ich einen kleinen Airbrush kompressor. Perfekt!

C_st un produit miracleC_st tr_ bonne id_ ?a _onomise beaucoup de peinture et en plus de ?a c_st r_lable c_st impeccable

Ciao! ho comprato questo articolo per trasformarlo in una pentola a pressione per castare silicone e resina, PERFETTO!!

Relaci_ calidad precio buena, realiza su funci_,

Tr_ bon rapport qualit prixJuste un peu dommage que le papillon de serrage soit trop pr_ du mano

THis did a great job of spraying my 88 ft fence on both sides. It was well worth the monney since it cost the same to rent a sprayer. Just be sure you get the air out of the line and then it works great. I do recomment this product.

I_ a cabinet guy. My current job is painting a kitchen and 3 bathrooms worth of doors and drawer fronts. I bought this thinking I_ use the pot and replace everything else. But to my wonderful surprise, it_ actually an awesome setup. Well worth every penny. I sprayed them all with 2 coats of primer and then 2 coats of lacquer. The spray was even and the gun didn_ malfunction one time. I liked it so much I bought another one. Outstanding product!!!I wanted to add pictures and videos but I can_ figure out how on iOS

I am using it for resin casting. My husband and I had to use loctite to keep the pressure. It took us three times to figure it out. But, now, it's perfect! Keep at it, if it's leaking, you can do it! PS. How to check for leaks: use a spray bottle with dish soap and water to spray everywhere there's a connection. Pressure it up and wherever there are bubbles, that's your spot to secure.