This is a very nice dividing head for the money. Pretty well finished and smooth operating, very little lash in the gearing.If you were thinking to use an ER32 chuck in the headstock taper note that the taper is #2 Morse not #7B&S as stated in the specifications. That is really good news given that the ER32 chuck adapter for #2 Morse is much cheaper than the #7 B&S. They are also available with 10mm drawbar threads so you can eliminate the chance of slipping in the taper.I checked the run-out specifications and found the following: Radial run-out of the spindle nose spec 0.0006" Actual <0.0002" Radial run-out of spindle taper nose spec 0.0008" Actual was about 0.001" Radial run-out of spindle taper hole 4" distant 0.0014" Actual was 0.0025" Radial run-out of test bar with 3-jaw chuck 0.0031" Actual was 0.003"So the specs were pretty close and my measurements might not be perfect. The run-out with the 3-jaw chuck was due the the chuck back-plate (spindle nose locating diameter had <0.0002 TIR). The locating diameter for the chuck had a run-out of 0.0025". That could be corrected by taking a few thousandths off the locating diameter, center the chuck and use the mounting screws to lock it in.

Great value for the price. The chuck ran out about .004” when it received it. When a slight modification, it can now be indicated in.I’m happy with the accuracy and workmanship. Now let’s see how it holds up. Great for a garage shop.

I looked at second hand dividing heads on ebay for a long time, but they were well worn. In the end I decided on a new unit and wasn't disappointed. Not so certain how long the rapid indexing location pin will last up, but it is easy to replace if it wears. It is a very solid head and suitable for any machine shop, let alone a home engineering workshop. Buy with confidence.

Very high quality product. As advertised! This dividing head is rigid as expected and can be used for professional work

Für den schmalen Geldbeutel und meine Zwecke echt hervorragend. Bedarf als ungeübter etwas mehr Übung

Wie gewohnt bei Chinaware sind messerscharfe Kanten keine Seltenheit. Das ist aber kein Hindernis, weil man ja sowieso alles auseinander baut, um dieses eklige Schmieröl zu entfernen. Die Genauigkeit des Morsekegels und des Backenfutters liegt beides bei 1/10 mm, so lala. Durch das Kegellager lässt sich die Drehachse spielfrei einstellen.

Was abit unsure at first as I had never heard of you but after doing some research on the Internet and reading the reviews, I placed my order. it came today and I have to say what a fast service you have given and the product is exactly what was pictured and described. It looks good and is solid, haven't tried it yet but can not see why it wouldn't perform like it says. Thanks

Very well made and good value for money professional item.

it is very good for the price

Great and does just what I needed to machine in places at different angles around a round bar