Customer Reviews for VEVOR 30L Pressure Feed Paint Pot Tank 8 Gallon Spray Gun Sprayer Regulator Air Agitator with Manual Mixing Agitator

converted this to a pressure pot - works great

Problemlos in einen pressure pot umgebaut. Sehr zu empfehlen!

This product has worked well for my small shop. Great value for money

Great product I am using this as a Pressure pot for reducing the bubbles in resin

El aspecto es solido y los cierres son apropiados para la presion que tienen que soportar

Impeccable pour obtenir une r_ine claire et sans aucune bulle.Vous devrez faire quelques modifications pour l'adapter mais elles sont la port_ de tous.

i do not use this for paint so if that is your use you can skip this review.I purchased it to use as a pressure chamber for casting urethane resin.The construction seems very good and sturdy the listing showed it as being rated for 30 psi but my tank is stamped .4 MPA which is 58.01 PSI and, that is what the pop-off is set at.The fittings on my unit were all metric so, I had to replace them with suitablepipe thread fittings from Menards. You can find many Youtube videos on how to perform this.

5 Gallon 20l Spray Paint Pressure Pot Agitator 1/4 Air Outlet Wood Coating

so I need to start this review by stating I'm not using the pressure pot for what it was designed for , I have converted it for resin casting . It would have been 5 stars apart from some of the fittings , mainly the regulator and gauge .The pot is relatively cheap with most of them _50 to _100+ more so I have taken that into account , pot is a well made thick gauge metal with a silicon seal in the lid , the air inlet has a side diverter meaning its not going to blow the resin etc out of the mould when you charge it . everything fitted to it is fine until you get to the pressure gauge and associated fittings , the body is plastic and already out of shape from shipping , feels like its going to fall apart just from handling however the biggest issue is its rated in MPA not PSI or BAR , which is easy to convert with google but an added complication and it goes way over what the vessel is rated for which could lead to some very nasty accidents if you don't get it right .The pressure vessel is easy to convert with a couple of extra fittings and PTFE plumbers tape but I would strongly recommend replacing the regulator with a decent PSI rated one before use .I did put 40 psi into the unit 24 hours ago and it has held the pressure . The inside is a decent size for most of the turning and casting work I would ever need to put in it .in summary - buy a decent gauge and its a very handy tool

I use it as a pressure chamber for resin casting, works great