Customer Reviews for VEVOR YP-9 Manual Bender, Soild Round Square Bar Metal Bender with 7 Bending Dies, Metal Rod Bar Bender Bending Tool for Construction Site Auto Repair

Very well made unit, super strong, excellent quality but unfortunately it will not bend 1 inch copper in Ireland as the specification for 1 inch copper tubing in Ireland is 27.4 mm, the seller was excellent to deal with & fully understand the issue. The maximum limit this unit will bend is 25mm copper tubing. If your copper tubing is 25mm I would highly recommend this unit.

Assembles ok, had to design/make a mounting plate so it could be mounted horizontal or vertical, also had to design and add an angle indicator so can track the bend amount. I used an eight inch protractor and mounted it on a plate I cut, I used 1/8" steel plate for the protractor base, and used 1/4" plate for the fab-table mount. The "indicator" is a piece of cloths hanger wire that I drilled/tapped for a 1/4-20 BHCS, ground the end of the indicator to a dull point so it could point more accurately at the degrees on the protractor, put some red paint on the tip. Used white sticky label paper under the protractor for better contrast of the numbers. Of note, the way the tube "Grab end" for the mandrel, it hits the follower wheel so it doesn't really get to 180 degrees, more like 165. So, I may do a fix in where I put a spacer under the tube grabber so that, the bend can actually start at 0 degrees instead of 15 degrees. Further all the dies/grabbers would each have to have their own spacer to get it right. The Grabber also does put a mark on the tube that is pretty deep so the hole in the grabber may need the hole "corners" to be broken so they don't mar as bad.

Once secured, it works well providing the pipe isn't too ridgid.

Muy bien cumple las expectativas.

Habe edelstahlrohre damit gebogen. Funktioniert gut! Man brauch viel Kraft. Der hebel könnte länger sein. Sehr massive Ausführung.

Gutes Produkt. Preis stimmt auch . Habe erst 3 Rohre damit gebogen aber gute Ergebnisse erzielt.

Cost-effective bender

Für das Geld ok. Solide gebaut

Cumple su función, aunque la calidad en general tampoco es premium. Para trabajos ocasionales está bien. La he probado en tubo de acero de 1 pulgada y sin problema. Requiere cierta práctica si tienes que hacer formas complejas.

Machine basique qui fait le boulot,on pourrait juste regretter d’avoir à polir la matrice pour les tubes cuivre sinon ça va.Ne regrette pas l’achat.