Customer Reviews for VEVOR 16Pcs Mortice Door Fitting Kit, DBB Lock Mortiser Kit with 3pcs Tungsten Steel Cutters & Accessories,Mortising Jig Tool Hole Saw Door Opener, for Wooden doors

It's fine as far as it goes. The cutters supplied are too big for most locks. They are an M10 thread and you would think that any similar mortiser would make their cutters with an M10 thread so I bought a 16mm dia cutter from Souber. But although the Souber mortiser looks virtually identical, it uses some sort of medieval thread of about 7.5mm. And I don't seem to be able to get hold of a 16mm dia cutter with an M10 thread.I shall probably find a suitable rod the same diameter as on my original mortiser and ask a friend with a workshop to run a tap of this medieval thread down into its end. If the Chinese company which made this advertised 16mm cutters, I would buy one but I can't find whether they do.Buy it if you are happy with oversized slots but you may have problems getting replacement cutters.

Saved me lots of money, easy to use. Used it on big expensive doors with equally as expensive hardwarePD

Bonne qualit, facile a utiliser

I have been looking for a latch jig for a long time! Glad I found this one and at a reasonable price.

Came in very handy for putting in 6 inch locks in 80yr old doors that had already been morticed to suit different sized locks. Probably would have been impossible without it. Only drawback is that to get it to slide on the rails you can't fully tighten both the adjustable rings or else it binds up so you have to be pretty careful the jig doesn't wander off a little. But for the price that's a minor complaint. Using it to mortice into endgrain 6 inches deep was pushing it to its absolute limit and it held up well, I'd another 6 inch lock to do in a 30 min firedoor and it did the mortice perfectly in less than a minute so I can only imagine how quickly this will go through a whole house of standard locks in regular light doors. This jig is an absolute steal at 70e and pays for itself within an hour, I'll probably upgrade the cutters before risking it on faceplate but recommend it 100% for trade use

tool is generally well made. cuts well too. I find it a bit rough when using a dewalt 20volt battery drill. The stem where the collar referenced the work has about 1/8" recess where the collar will eventually stop, this makes the resulting cut too deep . I corrected this by fitting a spacer into the recess so the collar can be flush with the rim of the stem

Everything shipped and arrived on time. Product works great.

Use it to mortise 7/16" x 3" 3/4 deep slots in 4 solid pine pocket door while they were in place work well. The only down side are the the router bits tread into the drill shaft and can not be easily be replaced, if at all

Well made product and works well. Would benefit from instructions though as no information included but managed to work it all out

For the price, I was afraid it might be lightweight and flimsy. But the online videos made it look substantial and indeed it is a well-built tool. We were surprised to find almost no mortise installation services in town - and the one that said they could do it would only do 1 3/4" doors. Our 1 3/8" interior door had few options until we found this tool. It worked great! Adjustable for width, height, and depth. Recommended. And for the price, a real bargain.