Customer Reviews for VEVOR Welding Table 30" x 20", 400lbs Load Capacity Steel Welding Workbench Table on Wheels, Folding Work Bench with Three 1.1" Slot, 3 Tilt Angles, Adjustable Height, Retractable Guide Rails

Pretty impressed with this table for the price. The only major con is the poor means of securing the table tilt angle which relies on small wing nuts. However as you're a welder bend up some flat bar, weld on a nut and your fabricated levers will sort the problem.

Prisvärt och det enda negativa är de två längsgående stängerna vid fötterna som endast kläms fast i plast-foten. Stängerna ramlar av väldigt lätt så jag kommer att förstärka infästningen. Något tungt för att vara mobilt.

For me and my business, it works well, just the right size and cheap price. Minus for the weak welds on the nuts for the height adjustment that I had to remake, and why put the knobs in different directions?. I also had to drill 2 holes on one leg.

Good quality. Nice finish. It took me 1-2 hours to put it together. Had to drill up one or two holes to make them allign for bolts. No problem. It is well worth the money.

I didn't find this hard to put together and I had no missing components, however there was a quality control issue. One of the legs was missing a drilled hole. Not an issue. I used the other as a template, marked and drilled it. But it dies speak to some of the problems others have had Once together it's a sturdy little industrial table People have clamped chop saws to them etc Mine is for holding components when welding outside If note currently 17 quid cheaper on vevors own website

Arrived well packed. All nuts and bolts were in the pack , but I needed a few washers. Of note , one of the legs didn't have the top hole drilled. No big issue Matched with the other and drilled Went together quickly and easily. It's sturdy and great quality. If you are happy to deal with the odd minor quality control issue , it's super value

Good quality product, but I found a couple of issues with the build instructions (e.g. the semicircular plates needed to be on the opposite side to the illustrations). Also, design wise I think they missed a couple of tricks: 1 - The nuts on the bolts holding the legs would be better with 'lock nuts' to allow better adjustment of the 'freeness', and to avoid them coming off if set too slack (I've done this, but had to also get longer bolts so the lock nuts 'engage') 2 - The table top clamping wing nuts are on opposite sides when build is complete (and the nicely painted sides are both on the outsides). This means the table top is clamped 'askew' (not by much, but avoidable), and that getting to the wing nut 'away from you' is 'fiddly'. My solution was to turn one side around, so I now have one fixing plate outside, and the other inside, and puts both wing nuts on the same side as the 'tool bar'... much easier to clamp now...

Great price/value and fast shipping, overall very happy with purchase. Seems to be of good quality and robust

Ett bra svetsbord, rekommenderas om man är i farten att köpa ett svetsbord som går att stuva undan och tar begränsad yta för någon som bara svetsar ibland i den mindre verkstaden. Smidig om man har hårt golv då det sitter hjul på kortsidan.

Great purchase In use all the time i purchased a 5mm piece of plywood for the top so to use as a tool bench fitted 6 high power magnets to one side dia12mm to stop the board from moving when tilted.