Good quality product, but I found a couple of issues with the build instructions (e.g. the semicircular plates needed to be on the opposite side to the illustrations).
Also, design wise I think they missed a couple of tricks:
1 - The nuts on the bolts holding the legs would be better with 'lock nuts' to allow better adjustment of the 'freeness', and to avoid them coming off if set too slack (I've done this, but had to also get longer bolts so the lock nuts 'engage')
2 - The table top clamping wing nuts are on opposite sides when build is complete (and the nicely painted sides are both on the outsides). This means the table top is clamped 'askew' (not by much, but avoidable), and that getting to the wing nut 'away from you' is 'fiddly'. My solution was to turn one side around, so I now have one fixing plate outside, and the other inside, and puts both wing nuts on the same side as the 'tool bar'... much easier to clamp now...
Hazze Larsson 
Weld, grind and Paint. 
Joaquim Matias 
hobbysvetsarn 
Craig Goldsmith 
