Customer Reviews for VEVOR 3.28 ft Cable Protector Ramp, 4 Pack of 1 Channel, 18000 lbs/axle Capacity Heavy Duty Rubber Speed Bumps, Floor Cord Cable Protector Wire Cover, for Residential Areas, Private Garages, Gardens

I normally connect cables from my house to my car to trickle charge the battery but as the neighbors drive over my extension cable, this vevor channel was a must. It is very strong and spacious enough to protect 2 big extensions cables. I will recommend this to everyone in the same situation. The pack contains 4 channels of 1meter EACH , so 4 meters in total, very important but the buyer did not mention this.

We needed a bumper to place our dog electric fence into. We put it inside the bumper and glued it onto our driveway. Worked great & looks great! Totally satisfied.

I bought for water diversion. They worked like I expected them to. No complaints.

Teile hatten eindeutige Gebrauchsspuren, die aber die Funktion nicht beeintr?chtigt haben.

These are clearly made from a high quality material. We drive over them daily getting into our garage. It protects our standard hose with no issues.

Sehr gutes Material, l?sst sich sehr gut mit der Stichs?ge schneiden. Gut, der Gummigeruch ist etwas streng, verfliegt aber nach ein paar Tagen??

These hose ramps are heavy duty rubber and fit our garden hose perfectly. Now the hose won_ get punctured when driven over. Glad I bought these to save me from buying new hoses all the time.

Received product today and was somewhat disappointed. The yellow stripe on two of the four pieces were crooked and scratched. Nothing like the photo shows. Most likely it will do what I will use them for.

I bought this for my driveway. Amazing performance, it is worth to buy it. I put both water and electric line in the tunnel of the bumper for my garde .Highly recommended

I just installed an EV charging station and did not like how the garage door would close on top of the charger's 3/4" cord. I glued these down across the garage threshold and cut a small gap on the end near the charger. After adjusting the garage door opener, the cord is no longer pinched by the garage door and easily has enough clearance to slide back and forth in the gap with the door down. I may have to secure them with concrete fasteners if the glue doesn't hold, but these have pre-formed holes for that. They do give off a bad smell at first, but that goes away in a day or two. Just air them out outside of the garage.