Customer Reviews for VEVOR House Floor Jack, 54"-150" Height Range, 11200 lbs Max Load Capacity, Adjustable Support Beam Basement Jack Post Pole for Leveling, Lift Support Steel Telescoping Jack for Temporary Support

The design of this floor jack is highly user-friendly, with the top plate, base plate, and tube welded together, eliminating complex installation steps. Even novices can easily complete the setup, making it very convenient to use!

I use it with a 4x4 to support a lean- to as I complete the surrounding ground.. Stays where I set it and the pre drilled holes help with anchoring. I'll be buying another soon

Whether for correcting sagging floors, reinforcing stair porches, or providing temporary support during home renovations, this jack can handle the task perfectly, offering a wide range of applications!

The thickened base plate and tube walls provide the jack with relatively strong load-bearing capacity. It remains stable during use, with no concerns about deformation or damage, making it suitable for long-term use.

Very robust piece of kit, packaged very well and delivered within 24 hours by UPS. Four stars rather than five as for shorter heights (eg. 6ft), I found the placement of the holes on the three cylinders meant the middle cylinder could not slot in between the inner and outer cylinders. So right now I have the middle cylinder lying about while the other two are helping to hold up my shed roof. Would have been better if the middle cylinder could always slot into the kit whatever the height required for the jack.

Can beat these for the price.

This order and product was good. However I have one of there battery chargers and a heat press that do not work properly and have tried to get help and this company has zero customer service after the sale.

This jack post was used under a cottage. Two things I would like. A black or grey post not bright orange. Easily fixed with paint. This post relies on a long screw for it adjusting. Which if you are using it on the shorter side of its range can be limiting. I would prefer bolts rather than pins for the sleeve adjustment. Once in place the jack is satisfactory

Fait parfaitement la job!

Product worked as designed - would be a 5 BUT on mine, the inner telescoping tube would not extend because protective plastic was still wrapped on the inner cylinder inside the outer tube from shipping. Lazy packaging cost me a lot of time, I tried all kinds of things. The final workaround was to extend the threaded adjuster enough to insert a pin below it, then use the adjustment bar to turn the screw and force the inner tube upward until it broke free. After that, remove all remaining plastic and verify smooth travel before use.