Customer Reviews for Vevor Cross Slide Table Milling Drilling Machine Worktable 5-1/2" X 12" X Y Axis

I received mine and took it apart and cleaned all the shipping coatings. Applied some ways oil to all sliding surfaces and spindle oil to the threaded hand wheel screws, adjusted the gibs to tighten up play/backlash. Set on my drill press and made a quick test run on some Delrin block. I was very pleased and now can use my drill press for some basic milling on light materials which is exactly why I purchased it. Mission accomplished and I'd recommend it.BTW it is very heavy so you'll most likely need to brace your drill press table - depending on its sturdiness.

The dials are in mm. The x y travel is 66mmX116mm. Solid build. The only flaw is a lot of backlash in the lead screw.

The slides are basicly good but need a bit of work. I scraped the machining marks out and scrapped the slides in. Also removed the sharp edges and the slides are great now. The cast iron is a bit on the soft side but it will be ok. I will add that I am a machine tool fitter machinist by trade.D.P.

A little rough around the edges but easy enough to square up and a solid build.Best Buy for the buck from what I found.

The slides on the table needed a little adjustment to get them to track easier and reduce sideways movement, but all in all a well made piece of kit, very pleased with it

Molto solida, ha un buon rapporto qualit prezzo.

As everyone else has stated, tear it down,file off burrs and grease well,I have milled a bit of 1/4 plate with this and it holds up well, I have a pretty beefy ITC press with good size bearings so a good steady lateral force is no problem, if your planning to attach this to a smaller press to do any milling, be careful because the Jacobs chuck is is just a tapered fit and it will fall out while your operating it.?It is pretty true and sturdy.minimal tightening on gibs will reduce unwanted XY movement .Lot_ of backlash on allthread drives, if you_e prepared for it , it_ not a problemI would purchase again

Usata ancora poco... sembra buona... con quel prezzo difficile trovare di meglio...Grazie

Really good table

I like every thing about it. I mounted it to my drill press and it fit's and work's perfect.